Produktname: Basler 9387900104 ICRM-15 Inrush Current Reduction Module
Marke: Basler
Produktcode: 9387900104 ICRM-15
Stichwörter: Basler
ICRM-15 Inrush Current
ICRM-15 Reduction
Basler ICRM-15 Inrush Reduction Module
Basler 9387900104 ICRM-15 Inrush Current Reduction Module
Basler 9387900104 Current Module
Basler ICRM-15 Inrush Current Reduction
Basler Current Reduction
9387900104 Current Reduction
Basler 9387900104 Module
Basler 9387900104 Inrush Current Reduction Module
ICRM-15 Inrush Current Reduction Module
Basler 9387900104 ICRM-15 Current Reduction
Basler Inrush
9387900104 Current Reduction
9387900104 ICRM-15 Inrush Current Reduction
9387900104 ICRM-15 Inrush Module
Basler ICRM-15 Current Reduction Module
Basler 9387900104 Current Module
9387900104 Inrush Current Module
Basler 9387900104 ICRM-15 Inrush Current
Inrush Current Reduction Module
Interessieren Sie sich für das Produkt Basler 9387900104 ICRM-15 Inrush Current Reduction Module vom Hersteller Basler mit dem Code 9387900104 ICRM-15? Kontaktieren Sie uns jetzt und holen Sie sich ein Angebot. Imtek Engineering, der schnellste und zuverlässigste Lieferant von Industrieausrüstung der Welt, wird Ihnen das beste Angebot machen!
Angebot per E-Mail erhalten: info@im-tek.com
Holen Sie sich jetzt ein Angebot für Basler 9387900104 ICRM-15 Inrush Current Reduction Module von unserem Live-Support-Team!
APPLICATION Applications where a voltage regulator is powered by a permanent magnet generator (PMG), auxiliary winding, or generator output (shunt fed) usually do not require the protection of an ICRM. These sources usually have a higher source impedance which inherently minimizes inrush current. Also, these sources are typically connected directly to the voltage regulator with no interposing relays, contactors, or switches. If this is the case, then no inrush occurs since the source voltage ramps up to its rated value. However, if rated or near rated voltage is applied to the voltage regulator, then some amount of inrush current is expected and an ICRM should be considered. Typically, voltage regulators in these applications receive power from a station service bus that is switched by a relay or contactor. Applications where a PWM type voltage regulator is powered by a low-impedance source need an ICRM to minimize the amount of inrush current. To summarize, if the voltage that powers the voltage regulator ramps up to nominal as the generator comes up to rated speed, then an ICRM is not needed. If this is not the case, an ICRM should be used. If you are unsure whether your application requires an ICRM, contact Basler Electric Technical Sales Support for assistance.ICRM Versions Two versions of the ICRM are available. Each version is uniquely suited to protect a specific family of Basler Electric products. Table 1 lists each ICRM model, its part number, and the compatible products.