Dynisco ATC770-1-3-3 Process Controller

ATC770-1-3-3 Process Controller

DYNISCO MODEL ATC770 1/4 DIN Self-Tuning Pressure and Process Controller
Description The ATC770 pressure and process controller, with its unique self - tuning algorithm, makes it possible to set up a process such as extrusion, quickly,
easily, and with a minimum of operator adjustment. Inputs include 350 Ohm strain gage, DC voltage and DC current, making the ATC770 compatible
with a wide variety of process transmitters, and thus able to control a number of factory functions. It is fully configurable with a combination of jumpers
and menu options, as well as providing a selection of readout option.
Features
Benefits
• • • • •
• • • • •
Unique self - tuning algorithm 3 levels of parameter security 3 fully programmable and assignable alarms
Dual 5 digit displays (red/green) and analog bargraph Automatic ramp to setpoint
• 24 Vdc transmitter power supply
• Optional RS - 485 serial communications, selectable for Modbus or Jbus
• Displays setpoint; deviation from setpoint; output %;
motor RPM; peak (high or low)
• IP65/NEMA 4X rated
Set and forget Allow different authorization levels Protect process with flexible schemes
Provide full process information Raise or lower setpoint under controlled
conditions
• Provides excitation for 2 or 4 wire transmitters
• Send and receive information from PLCs, PCs, etc.
• Display process in familiar units
• Useable in harsh environments
c Specifications Performance Characteristics Power supply: 100 to 240 Vac 50/60 Hz, switching
Power consumption: 15 VA maximum Operating temperature: 0˚ to 50˚C
Storage temperature: -20˚ to +70˚C Humidity: Maximum 85% RH non - condensing
Weight: 1.43 lbs
Inputs Input: Selectable between strain gage and linear via jumper and configuration
Strain gage input: 350 Ohm, 2 to 4 mV/V; excitation 10 V ±7% Input signal: -25% to +125% full scale
Shunt calibration: With or without shunt resistor (40.0% to 100.0%) Linear input: Selectable between 0 to 5 Vdc, 0 to 10 Vdc, 0 to 20 mA,
4 to 20 mA scaleable
Auxiliary power supply: 24 Vdc/1.5 W for two or four wire transmitter Input impedance: <10 Ohm for linear current input; >165 kohm for linear voltage input
Sampling time: 50 ms typical Digital input: One input, voltage free contact closure. May be programmed for one of
the following functions: a. Alarm reset b. Peak reset c. Alarm and peak reset
Control Algorithm Control type: PID with Integral Preload and Anti - Reset Windup
Outputs Control output: Selectable between 0 to 10 Vdc, -10 to +10 Vdc, 0 to 5 Vdc, 0 to 20 mA, 4 to 20 mA
Retransmission output: Selectable between 0 to 10 Vdc, -10 to +10 Vdc, 0 to 5 Vdc,
0 to 20 mA, 4 to 20 mA fully scaleable high and low limits (allows direct or reverse action)
Serial Communications (Optional) Serial interface: RS - 485
Protocol supported: Modbus and Jbus, selectable
Other Options Remote setpoint input: 0 to 20 mA, 4 to 20 mA, 0 to 10 V 160
Four opto - isolated digital inputs