PICMG® CompactPCI® Serial standard (CPCI-S.0) peripheral slot CardAssembly unit comprising carrier board SK2-SESSION & XMC Module DU1-MUSTANGSingle size Eurocard 3U 4HP 100x160mm2CPCI-S backplane connector P1XMC Module carrier board, equipped with XMC connector J15PCI Express® Gen1 (2.5Gbps) or Gen2 (5.0Gbps) supportedBidirectional PCIe redriver/repeater for optimum signal integrityPCI Express® clock buffer for optimum signal integrityXMC Module single-width mezzanine card 139mm x 74mm, stack height 10mmEquipped with dual-port UARTPLX Oxford 950 UART w. 128-byte transmit/receive FIFOAsynchronous baud rates up to 15MbpsWindows® & Linux device driver support5kV rms isolation barrier RS-485/RS-422 transceivers (Analog Devices)Configurable as half- or full-duplex±15 kV ESD protection on RS-485 input/output pinsData rate 16 MbpsConnect up to 256 nodes on one bus (driver enable control via DTR)Open- and short-circuit, fail-safe receiver inputsHigh common-mode transient immunity >25 kV/µsThermal shutdown protectionTwo front bezel male 9-pin D-Sub connectorsRS-485 ports isolated against each other and board circuitry 250VACOn-board DIP-switches for full/half-duplex setting, and line termination on/offSuitable e.g. for CompactPCI® Serial System Slot Controller SC1-ALLEGRO (CPU Board)Suitable e.g. for CompactPCI® PlusIO System Slot Controller PC1-GROOVE (CPU Board)Commercial and industrial temperature rangeRugged solution (coating/sealing available on request)Long term availabilityRoHS compliant