Eurotherm SP-LA102595 Er-Pl X Serial Configuration Cable
/

TECHNICAL SPECIFICATION
Additional information and documentation available on www.eurotherm.co.uk
ELECTRICAL Nominal current (at 45 Deg. C) Nominal voltage Supply frequency
Electronics supply Power dissipation Fusing Cooling Load OPERATING Inputs
16A to 400A 100V to 500V (+10%, -15%) as product code 40 to 70 Hz automatic adaptation
Internal or optionally 115V or 230V external (10VA) 1.3 watts per amp High speed fuses: External for 16A to 100A (order separately), internal for 125A to 400A
Natural cooling up to 100amps Fan cooled from 125 amps upwards (25VA fan)
Any type of single phase load (except capacitive)
Diagnostics
0-5V or 0-10V (Input impedance >100K) 0-20mA or 4-20mA (input impedance 250 Ohms)
Logic: 5V, 10V or 20mA Digital Comms (optional): RS422 or RS485 Logic (ON/OFF)
Burst firing (selectable soft start) Advanced Single Cycle Phase Angle (selectable ramp)
Power - calculated from instantaneous measurements
RMS voltage
RMS current V2 I2 Automatic transfer I2 <->P Automatic transfer I2 <->V2
Open Loop Better than ±1% of full scale Analogue- by potentiometer or by external signal
Digital- by communications bus (optional) Either chop-off (with alarm) or revert to phase angle and reduce firing angle
Analogue 0-10V or 4-20mA isolated (accuracy ±1%) Digital via comms link Diagnostics port available for use with model 260 Diagnostic unit
DIGITAL COMMUNICATIONS Protocol
PROFIBUS-DP or MODBUS
ALARMS Mains Load Thyristors
Under or over voltage, frequency out of range Over current or load fault (static or dynamic)
Short circuit or over temperature (fan cooled units)
Firing modes
Control mode
Linearity and stability Input limit Current or voltage limit Retransmission
ENVIRONMENT Temperature Humidity Altitude Atmosphere Pollution Protection (mechanical)
Dimensions Weight Mounting
0 to 45°C operating, -10 to 70°C storage 5% to 95% RH Non condensing, non streaming
2000 metres maximum Non explosive, non conductive and non corrosive Pollution degree 2 admissible, defined by IEC664
IP20 on front face according to IEC529 16 to 100A: 225mm (H) x 116mm (W) x 169mm (D)
125 to 400A: 470mm (H) x 133mm (W) x 260mm (D) 16A to 100A: 3.2kg. 125 to 400A: 11.5kg
DIN rail mounting up to 100amps Bulkhead mounting available for all units
EUROPEAN DIRECTIVES Safety EMC- Immunity EMC- radiated emission EMC- conducted Emmission
UL approval
The TE10P carries the CE mark to show compliance with the European Low Voltage Directive 73/23/EEC
Conforms to: EN 500082-2, EN 61000-4-2, EN 61000-4-4, ENV 50204, ENV 50140, ENV 50141
Conforms to: EN 55011 class A Conforms to: EN 500081-2 without fiter in Burst Firing modes for resistive loads up to 100amps. An external
filter may be required for other operating conditions Conforms to IEC 1800-3 (EN610800-3) without filter
For use in second (industrial) environment Products ≤100A are UL approved