Resistive material moisture measuring device with integrated measuring needlesGENERAL:Compact and robust measuring device for fast evaluation of material moisture in firewood, timber, flake board, inlay, plaster, cement and lots more. A suitable characteristic is selected with help of material table on the rear side of the device before measuring. The material is contacted by pressing the measuring needles into it. The measured value is displayed only a short time afterwards. The device is especially designed for precise firewood and timber measurements, however, a lot of additional building materials can be rated.Material tables on rear side of deviceIntegrated, exchangeable measuring needlesMoisture rating (wet / dry) via bar graphDisplay of material moisture or water contentIntegrated temperature compensationCharacteristic curve displaySPECIFICATIONS:Measuring principle:
resistive material moisture measurement acc. to DIN EN 13183
Characteristic curves:
3 different wood groups (h.01, h.02, h.03) for a total of 130 wood types and 8 different building material curves (c.01, c.02, c.03, c.04, c.05, c.06, c.07, c.08)
Measuring range:
0.0 ... 100% material moisture (depends on selected characteristics)
Moisture rating:
in 6 steps (wet ... dry)
Resolution:
0.1% (<20%), 1% (> 20%)
Accuracy (at nominal temperature = 25 ° C)
Wood:
± 0.2% material moisture (Deviation to wood characteristic curve in range 6 ... 20%)
Building materials:
± 0.2% material moisture (deviation to corresponding characteristic curve)
Scope of supply:
device, 2 needle protection caps, battery, calibration protocol, manual