S 30..K  Plummer Block
Housings are split housings for the fitting of series 230..K spherical roller
bearings. These housings can be supplied suitable for spherical roller bearings
with cylindrical bore, on request. S 30..K housings are supplied as standard
with felt seals. For extreme operating conditions however, the housings are
available with additional V-ring or labyrinth seals. If the shaft terminates in
the housing, an end cover (material GG20) is supplied instead of the seal. S
30..K Plummer Block Housings are manufactured as standard, from Grey Cast Iron
GG25. Housings from Spheroidal Cast Iron GGG40 or Cast Steel GS45 are also
available for bearing applications requiring higher loads. This housing series
is designed for grease lubrication. In the majority of applications the grease
applied during assembly is sufficient to last until the general inspection.
Should regeasing be necessary due to operating conditions, this can be carried
out using the grease hole incorporated as standard.