PICMG® CompactPCI® Classic (CPCI 2.0) peripheral slot CardAssembly unit comprising carrier board CK2-SESSION & XMC Module DU1-MUSTANGSingle size Eurocard 3U 4HP 100x160mm2Backplane connector J1 (32-bit, 33/66MHz) 3.3V/5V VIOXMC Module carrier board, equipped with XMC connector J15XMC Module single-width mezzanine card 139mm x 74mm, stack height 10mmEquipped with dual-port UARTPLX Oxford 950 UART w. 128-byte transmit/receive FIFOAsynchronous baud rates up to 15MbpsWindows® & Linux device driver support5kV rms isolation barrier RS-485/RS-422 transceivers (Analog Devices)Configurable as half- or full-duplex±15 kV ESD protection on RS-485 input/output pinsData rate 16 MbpsConnect up to 256 nodes on one bus (driver enable control via DTR)Open- and short-circuit, fail-safe receiver inputsHigh common-mode transient immunity >25 kV/µsThermal shutdown protectionTwo front bezel male 9-pin D-Sub connectorsRS-485 ports isolated against each other and board circuitry 250VACOn-board DIP-switches for full/half-duplex setting, and line termination on/offCommercial and industrial temperature rangeRugged solution (coating/sealing available on request)Long term availabilityRoHS compliant