Omal SR15 F03-F05 Pneumatic Actuator

1.Energized and self-lubricated stripsLess friction between piston and cylinderIt prevents the bonding of the seal to the cylinder even after long periods of inactivity2.Slots, bushes and pins made by steel with hardness higher than 50 HRCHigher resistance to the forces inside the actuator3.Rolling friction between piston and slotLess friction4.Scotch yoke with rolling friction (transforming rotary motion into linear motion using piston and shaft without teeths/gears)Reduced friction between piston and shaft with consequently less wear on the relevant partsEmpowered Breakaway Torque (BTO & BTC)Smaller volume/size than rack and pinion actuators (with the same torque) therefore less space required for installationLess weight than the rack and pinion (-30% kg / Nm), with consequent savings on the construction sizing of the plant/equipmentLower air consumption compared to the rack and pinion actuators (-40% air cm3/Nm for Double Acting and -20% air cm3/Nm for Spring Return) therefore less load on the compressor or the possibility of using a smaller compressor's size.5.Rolled cylinderLess wear of the energized ties thanks to the low roughness of the surface (0.15 micron Ra)From sizes bigger than DAN15, NAMUR interface for solenoid valve is already integrated.No need for extra plate.100% in- house manufacturing process technologyMaximum control and accuracy in all the stages of the manufacturing processATEX CertificateInstallation is allowed in a potential explosive environmentSIL 3 CertifiedGuarantee of the high level of functional safety.